How To Install The Wireless Handle On Rail Electric Transfer Car?

In order to make the operation of the rail electric transfer car more convenient, some customers require that the electric flat transfre car be equipped with a wireless handle, that is, a wireless remote control handle, which can realize the remote wireless control of the rail electric transfer car without coil interference. So, how to install the wireless handle?

Wireless control handle: it is mainly composed of wireless transmitting device and wireless receiving device. When purchasing, the products of regular manufacturers should be used. Cottage products will lead to receiving insensitivity or failure, and the installation will begin after purchasing.

In the process of installing wireless handle on rail electric transfer car, first of all, it is necessary to check whether the purchased products are available and whether the wireless PCI interface is reserved on the electric transfer car.

Then install the transmitter on the electric transfer car and tighten the fixing screws at both ends of the main board.

Finally, start the rail electric transfer car, select the wireless control on the control platform, and import the driver of the transmitter.

After debugging, test whether the wireless handle can operate the electric transfer car normally. If you can't operate, it's usually caused by not plugging in or driver mismatch.

In addition, if there is no reserved interface on the electric rail transfer car, it is necessary to install PCI conversion interface on the computer motherboard of the electric transfer car.